Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » quick_guide » power_protection
Trace:
quick_guide:power_protection

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
quick_guide:power_protection [2017/12/05 11:42]
gcooper 		quick_guide:power_protection [2017/12/05 11:43] (current)
gcooper
Line 57: Line 57:
  
 ===== Test Your UPS ===== ===== Test Your UPS =====
 +
 +<note warning>If you just yank the power cord with the PC booted fully into the OS, there is a significant chance you will cause filesystem damage (data loss) and Windows may not boot up again!</note>
  
 Testing existing UPS units in-place is not simple and **failing UPS units can cause very difficult-to-troubleshoot problems**.  Generally, we mark UPS units when we install them with the date of installation.  Then, we refer to that date when any question of UPS efficacy comes up.  We have found new UPS units are generally quite reliable up to 2.5 years of age.  After that point, we just replace them rather than spend time troubleshooting them...it's just more cost-effective. Testing existing UPS units in-place is not simple and **failing UPS units can cause very difficult-to-troubleshoot problems**.  Generally, we mark UPS units when we install them with the date of installation.  Then, we refer to that date when any question of UPS efficacy comes up.  We have found new UPS units are generally quite reliable up to 2.5 years of age.  After that point, we just replace them rather than spend time troubleshooting them...it's just more cost-effective.
  
 To test a UPS unit in place, we will generally reboot a PC just to the POST (BIOS) screen, then pause the boot (usually just by hitting the PAUSE or DEL key).  Then we yank the power cord so that the UPS cuts over to battery power.  If the PC stays up (doesn't immediately power off), we check the run-time.  If the UPS will keep the PC up for 5 or 10 minutes, we call that good.  While this is an unscientific test, it's fairly easy to do and indicative of the state of the UPS unit. To test a UPS unit in place, we will generally reboot a PC just to the POST (BIOS) screen, then pause the boot (usually just by hitting the PAUSE or DEL key).  Then we yank the power cord so that the UPS cuts over to battery power.  If the PC stays up (doesn't immediately power off), we check the run-time.  If the UPS will keep the PC up for 5 or 10 minutes, we call that good.  While this is an unscientific test, it's fairly easy to do and indicative of the state of the UPS unit.
- 
-<note warning>If you just yank the power cord with the PC booted into Windows, there is a big chance you will cause filesystem damage (data loss) and Windows may not boot up again!</note> 
  
 ===== When the Power Goes Out ===== ===== When the Power Goes Out =====
quick_guide/power_protection.1512499341.txt.gz · Last modified: 2017/12/05 11:42 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki