Table of Contents

Viking PA-2A Paging System Integration

General Info: http://wiki.ipitomy.com/wiki/Overhead_Paging

More General Info: http://www.voip-info.org/wiki/view/Asterisk+Paging+and+Intercom

Using an ATA (FXS): http://www.asteriskpbxsystems.com/asterisktopaging.html

FreePBX: http://wiki.freepbx.org/display/FOP/Using+an+SPA3102+FXO+Port+to+connect+with+Valcom+Paging+units

Viking PA-2A

Viking PA-2A Manual

https://www.vikingelectronics.com/product-details.php?pid=317

http://www.grandstream.com/company/news/grandstream-networks-fxs/fxo-devices-certified-intercom-and-paging-systems-viking

Viking PA-2A Diagram

Viking PA-2A DIP Switches

  1. Adjust the paging volume knob on the Viking PA-2A to a middle position (not off)
  2. Connect an FXO port to the Viking PA-2A using screw terminals 5 & 6 (Trunk or Paging Port)
  3. Set the DIP switches to 4 & 5 to ON (the rest off)

Viking PA-2A Dip Switches

FreePBX and Linksys SPA-3102

The Cisco/Linksys SPA-3102 is a multi-function ATA with one FXS and one FXO port (LINE). We can use the FXO port to drive a separate paging amplifier.
Reset the SPA to factory using an analog phone. Dial to access in the IVR menu, then dial 73738# and lastly press 1 to confirm the reset.
  1. Configure the Viking PA-2A as above
    1. Connect the FXO port to screw terminals 5 & 6 on the SPA-3102
    2. Connect the speaker horn to screw terminals 9 & 10 on the SPA-3102
  2. Configure the Linksys SPA-3102
    1. Connect the SPA-3102 WAN port to the same network as your PBX
    2. Connect your PC to the LAN port
    3. Router → WAN Setup (tab)
      1. Configure a static IP address for the WAN port (or a DHCP reservation)
    4. Voice → Info (tab)
      1. Note the Line Voltage (24V?)
    5. Voice → PSTN Line (tab)
      1. Configure the Line-in-Use Voltage the same voltage as previously noted
      2. Configure the Proxy and Registration settings
        1. ProxyPBX IP address
        2. Register → no
        3. Make Call Without Reg → yes
        4. Ans Call Without Reg → yes

Proxy and Registration Settings for Paging

Create a Paging Trunk

FIXME

Grandstream UCM610X PBX

  1. Use an FXO port on the Grandstream UCM610X PBX
  2. Turn ON Talk Battery feature of paging amp
    • DIP switch 4 ON for Viking PA-2A
  3. Create a new Analog Trunk named Paging
  4. Create a new Outbound Route also named Paging
    • Set the Trunk to Paging
    • Set the Dial Pattern to 999
    • Strip the digits used to access the trunk or you will hear the dialed tones when paging

:!: Evidently, on the Grandstream PBX, you can not strip all the digits as the PBX won't let you enter 3 to strip out the tones for 999.