Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » quick_guide » ras_client_update
Trace:
quick_guide:ras_client_update

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
quick_guide:ras_client_update [2020/11/24 13:01]
gcooper 		quick_guide:ras_client_update [2020/11/24 13:25] (current)
gcooper
Line 5: Line 5:
   * Installing Parallels RAS Client updates via Policy **does not require administrative permissions**   * Installing Parallels RAS Client updates via Policy **does not require administrative permissions**
   * **Do not enable** ''Allow only clients with the latest security patches'' until all clients are already updated   * **Do not enable** ''Allow only clients with the latest security patches'' until all clients are already updated
-  * You can check the RAS Client version in the **RAS Server Console -> Device Manager**+  * You can check the RAS Client version in the **RAS Server Console -> Device Manager** {{ :quick_guide:parallels_ras_server_update_policy.png?direct&400|RAS Policy Update Settings}}
  
 ==== RAS Server Console ==== ==== RAS Server Console ====
Line 18: Line 18:
 ==== RAS Client PC/Device ==== ==== RAS Client PC/Device ====
  
-  - **Connect** your Parallels Client to the RAS Gateway Server+  - **Connect or reconnect** your Parallels Client to the RAS Gateway Server 
     * This will apply the new Policy to this device     * This will apply the new Policy to this device
-  - Log out, then back in or **Reboot** the PC or Device+  - Log out, then back in or **Reboot** the PC or device
     * You will be prompted to update the Parallels RAS Client     * You will be prompted to update the Parallels RAS Client
   - **Select** ''Update''   - **Select** ''Update''
 +
 +{{ :quick_guide:parallels_ras_client_connected.png?direct&400|Connected Client}}
  
 ==== Troubleshooting ==== ==== Troubleshooting ====
  
   - Verify the Policy filtering to make sure the policy applies    - Verify the Policy filtering to make sure the policy applies 
-  - Connect the RAS Client to the RAS Gateway Server, to make sure the policy is applied, then reboot the PC or device again+  - Connect or reconnect the RAS Client to the RAS Gateway Server, to make sure the policy is applied, then reboot the PC or device again 
 + 
 +{{ :quick_guide:parallels_ras_client_update_after_reboot_pc.png?direct&300 |Select Update}}
quick_guide/ras_client_update.1606248082.txt.gz · Last modified: 2020/11/24 13:01 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki