User Tools
voice:pbx:freepbx:freepbx_e911
This is an old revision of the document!
Table of Contents
FreePBX e911 Emergency Dialing
Simple Situations
In simple situations, you can just add 911 to the Dial Patterns that will use this Route on the default outbound route and specify the caller ID for the outbound trunk or route.
You will need:
- At least one DID
- e911 service for that DID
- e911 service properly configured with local address
- Outbound CID specified and working
911dial pattern added/permitted/matched on the default outbound routeEmergencyflag on the default outbound route
Situations with Multiple Locations
When you have multiple locations, you will need:
- At least two DIDs
- e911 service for the two DIDs
- e911 service properly configured with local addresses on the DIDs
- Outbound CID specified and working
911dial pattern added/permitted/matched on the outbound route
voice/pbx/freepbx/freepbx_e911.1422843322.txt.gz · Last modified: 2015/02/01 19:15 by gcooper
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
