====== Zyxel MWR102 Travel Router, AP and Bridge ======

**Manual**: {{ :networking:wireless:mwr102.pdf |}}

===== Wireless Client Bridge =====

To enable Client mode (to bridge an existing WiFi network to Ethernet), follow these steps:

  - Flip the switch on the ZyXEL's side to AP mode
  - Save a backup of the current configuration & settings
  - Configure your PC with a static IP such as 192.168.100.22
  - Log in to the ZyXEL's setup page at **http://192.168.100.1**
  - Save a backup of the current configuration if you wish
  - Click **Wireless -> Basic Settings**
  - Click **Wireless Mode -> Client** (drop list)
  - Click **Wireless -> Site Survey** to refresh the list of WiFi networks in range
  - Select your network (SSID) and then **Next**
  - Select your encryption method and enter your passphase
  - Click finish

:!: In client mode both Ethernet jacks pass through the Internet connection that allows two devices to connect to a WiFi network.