Virtual Architects Support Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== FreePBX e911 Emergency Dialing ======

:!: **New Requirements**: https://community.freepbx.org/t/freepbx-new-e911-compliance-features/64569

:!: **New Requirements**: https://wiki.freepbx.org/display/FOP/Set+up+Emergency+Service%28E911%29+calling+requirements

http://wiki.freepbx.org/display/FPG/Outbound+Routes+Configuration+Examples

https://www.voip-info.org/asterisk-dialplan-patterns/

===== Simple Situations with One Location =====

In simple situations, you can just add ''911'' to the ''Dial Patterns that will use this Route'' on the default outbound route and specify the caller ID for the outbound trunk or route.

You will need:

  * At least one DID
  * e911 service for that DID
  * e911 service properly configured with local address
  * Outbound CID specified and working
  * ''911'' dial pattern added/permitted/matched on the default outbound route

===== Situations with Multiple Locations =====

When you have multiple physical locations, you will need:

  * At least two DIDs
    * DID #1 is used for location #1
    * DID #2 is used for location #2
  * e911 service for the two DIDs
    * e911 location #1 physical address configured for DID #1
    * e911 location #2 physical address configured for DID #2
  * An separate outbound route named ''Emergency'' just for emergency calls
    * ''911'' dial pattern added/permitted/matched on the ''Emergency'' outbound route
      * But not on the default outbound route
    * ''Emergency'' flag enabled on the ''Emergency'' outbound route
      * But not on the default outbound route
  * Configure the ''Route CID'' on the ''Emergency'' outbound route
    * Use DID #1 assuming location #1 is the primary or has the most extensions
    * Select to ''Override Extension'' CID
      * In case any extensions have their own CID defined
  * Modify all extension definitions for extensions at location #2
    * Specify the ''Emergency CID'' as the DID for location #2
    * This will override the outbound ''Route CID'' when dialing from extensions at location #2
Virtual Architects Support Wiki

User Tools

Site Tools

Page Tools
