Virtual Architects Support Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Bonding Interfaces with MikroTik ======

http://wiki.mikrotik.com/wiki/Manual:Interface/Bonding

:!: Also called link aggregation

<file>
/interface bonding add comment="Bonded interface between X router and Y switch" \
  mode=802.3ad name=name-of-bond slaves= ether11,ether12
</file>

===== With Cisco Switches =====

http://blog.bravi.org/?p=343

:!: Cisco calls bonded interfaces EtherChannel

==== RouterOS ====

<file>
/interface bonding add slaves=ether11,ether12 mode=802.3ad lacp-rate=30secs link-monitoring=mii \
  name=rtr-01_sw-1g-01_bond
</file>

==== Cisco IOS ====

<file>
!
interface range gigabitEthernet 1/47-48
   channel-protocol lacp
   channel-group 1 mode active
!
interface port-channel 1
   description rtr-01_sw-1g-01_bond
   switchport
   switchport mode access
   swichport access vlan XX
!
</file>

=== Check Status ===

<file>
show lacp internal
</file>

Virtual Architects Support Wiki

User Tools

Site Tools

Page Tools