User Tools
voice:phones:yealink:yealink_prov
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
voice:phones:yealink:yealink_prov [2014/12/13 14:32] gcooper |
voice:phones:yealink:yealink_prov [2015/03/17 16:08] (current) gcooper |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| **Yealink FTP Server**: ftp:// | **Yealink FTP Server**: ftp:// | ||
| + | |||
| + | ===== DHCP ===== | ||
| + | |||
| + | **Windows DHCP Server**: http:// | ||
| + | |||
| + | * Not all Yealink firmware supports RPS | ||
| + | * RPS is supported on brand new phones | ||
| + | * You can also use DHCP Option 66 to pass a provisioning URL to a Yealink phone | ||
| + | * Be patient when reprovisioning as it sometimes takes a few minutes and the phone may reboot again | ||
| + | * Use the same URL as with RPS | ||
| + | * FreePBX Commercial EPM example URL: http:// | ||
| ===== Yealink Redirection and Provisioning Service (RPS) ===== | ===== Yealink Redirection and Provisioning Service (RPS) ===== | ||
| Line 19: | Line 30: | ||
| :!: **Not all firmwares support RPS.** | :!: **Not all firmwares support RPS.** | ||
| + | ===== FreePBX Commercial End Point Management ===== | ||
| + | |||
| + | :!: The firmwares downloaded by the FreePBX EPM do not support RPS as of 12/13/14. | ||
| + | |||
| + | :!: You can get the phones to change VLANs with auto-provisioning setttings. | ||
| + | |||
| + | - New phone boots (has RPS-compatible firmware) | ||
| + | - Phone gets IP address from DHCP server on ' | ||
| + | - Phone contacts RPS and gets a provisioning URL | ||
| + | - Phone gets configuration from provisioning server | ||
| + | - Phone downloads and upgrades its firmware from the provisioning server (if newer) | ||
| + | - Phone reboots into proper VLAN with proper configuration | ||
| + | - Phone gets IP address via DHCP from PBX DHCP server | ||
| + | - Phone registers extension with PBX | ||
| + | |||
| + | Configuration settings needed with phones on a separate VLAN but sharing a CAT5 cabling plant (using the switches in the phones): | ||
| + | |||
| + | < | ||
| + | network.lldp.enable = 0 | ||
| + | network.vlan.dhcp_enable = 0 | ||
| + | network.vlan.internet_port_vid = nnn | ||
| + | network.vlan.internet_port_priority = 5 | ||
| + | network.vlan.internet_port_enable = 1 | ||
| + | </ | ||
| + | :!: LLDP may confuse the phone VLAN functionality. | ||
voice/phones/yealink/yealink_prov.1418506341.txt.gz · Last modified: 2014/12/13 14:32 by gcooper
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
