Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » voice » pbx » grandstream_pbx
Trace:
voice:pbx:grandstream_pbx

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
voice:pbx:grandstream_pbx [2022/10/26 11:34]
gcooper 		voice:pbx:grandstream_pbx [2022/10/26 15:01] (current)
gcooper
Line 290: Line 290:
 {{ :voice:gateway:grandstream_monitor_vm_2.png?direct&728 |Monitor Shared Mailbox}} {{ :voice:gateway:grandstream_monitor_vm_2.png?direct&728 |Monitor Shared Mailbox}}
  
-==== Night Mode ====+===== Night Mode =====
  
-FIXME Needs testing!+FIXME Needs testing! Problems! 
 + 
 +https://forums.grandstream.com/t/night-mode-toggle-blf-on-ucm62xx-resolved/39206 
 + 
 +http://onthewire.us/2019/10/11/grandstream-ucm-day-night-mode-and-time-holiday-mode/
  
   - Go to ''Inbound Routes''   - Go to ''Inbound Routes''
-  - Go to ''Set Global Inbound Mode'' (top)+  - Go to ''Set Global Inbound Mode'' at the top
   - Select ''Enable'' and leave everything else as-is   - Select ''Enable'' and leave everything else as-is
   - ''Save'' & ''Apply''   - ''Save'' & ''Apply''
-  - Go back to ''Inbound Routes'' +  - Go back to ''Inbound Routes'' and edit your desired/normal inbound route 
-  - Enable Route-Level Inbound Mode ( this button is somewhere in the middle of the page ) +  - Select ''Enable Route-Level Inbound Mode'' in the middle of the page 
-  - Enter Any code you like for ''Inbound Mode Suffix'' , for example enter ''80''. +  - Enter Any code you like for ''Inbound Mode Suffix'', for example enter ''80'' 
-  - Enable ''Inbound Multiple Mode''. +  - Enable ''Inbound Multiple Mode'' 
-  - Setup your Mode 1 route for night mode IVR. +  - Setup your ''Mode 1'' route for night mode IVR/destination 
-  - Save & Apply. +  - ''Save'' & ''Apply'' 
-  - Go to your Deskphone, Setup BLF Button with same value as “Inbound Mode Suffix”, ( I used 80 )+  - Go to your deskphone and configure a BLF button with same value as ''Inbound Mode Suffix'', for example ''80''
  
 ===== Troubleshooting ===== ===== Troubleshooting =====
Line 313: Line 317:
  
 If you enable CallerID, but the analog line doesn't have that service, you may not get incoming calls. If you enable CallerID, but the analog line doesn't have that service, you may not get incoming calls.
 +
 +==== Transferring Calls to External Numbers ====
 +
 +**PBX Settings -> SIP Settings -> ToS -> RTP Keepalive -> 5**
 +
 +{{ :voice:pbx:grandstream_ucm_forward_to_external.png?direct&600 |Transferring to External Numbers}}
voice/pbx/grandstream_pbx.1666805699.txt.gz · Last modified: 2022/10/26 11:34 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki