Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » voice » pbx » freepbx » freepbx_e911
Trace: • freepbx_cli
voice:pbx:freepbx:freepbx_e911

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
voice:pbx:freepbx:freepbx_e911 [2015/02/01 19:36]
gcooper 		voice:pbx:freepbx:freepbx_e911 [2020/02/25 11:14] (current)
gcooper
Line 1: Line 1:
 ====== FreePBX e911 Emergency Dialing ====== ====== FreePBX e911 Emergency Dialing ======
 +
 +:!: **New Requirements**: https://community.freepbx.org/t/freepbx-new-e911-compliance-features/64569
 +
 +:!: **New Requirements**: https://wiki.freepbx.org/display/FOP/Set+up+Emergency+Service%28E911%29+calling+requirements
 +
 +http://wiki.freepbx.org/display/FPG/Outbound+Routes+Configuration+Examples
 +
 +https://www.voip-info.org/asterisk-dialplan-patterns/
  
 ===== Simple Situations with One Location ===== ===== Simple Situations with One Location =====
Line 23: Line 31:
     * e911 location #1 physical address configured for DID #1     * e911 location #1 physical address configured for DID #1
     * e911 location #2 physical address configured for DID #2     * e911 location #2 physical address configured for DID #2
-  * An separate outbound route just for emergency calls named ''Emergency'' +  * An separate outbound route named ''Emergency'' just for emergency calls 
-    * ''911'' dial pattern added/permitted/matched on the ''Emergency'' outbound route but not the default outbound route+    * ''911'' dial pattern added/permitted/matched on the ''Emergency'' outbound route 
 +      * But not on the default outbound route
     * ''Emergency'' flag enabled on the ''Emergency'' outbound route     * ''Emergency'' flag enabled on the ''Emergency'' outbound route
 +      * But not on the default outbound route
   * Configure the ''Route CID'' on the ''Emergency'' outbound route   * Configure the ''Route CID'' on the ''Emergency'' outbound route
     * Use DID #1 assuming location #1 is the primary or has the most extensions     * Use DID #1 assuming location #1 is the primary or has the most extensions
     * Select to ''Override Extension'' CID     * Select to ''Override Extension'' CID
-  * Configure all extension definitions at location #2+      * In case any extensions have their own CID defined 
 +  * Modify all extension definitions for extensions at location #2
     * Specify the ''Emergency CID'' as the DID for location #2     * Specify the ''Emergency CID'' as the DID for location #2
     * This will override the outbound ''Route CID'' when dialing from extensions at location #2     * This will override the outbound ''Route CID'' when dialing from extensions at location #2
    
voice/pbx/freepbx/freepbx_e911.1422844604.txt.gz · Last modified: 2015/02/01 19:36 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki