User Tools
voice:pbx:freepbx:freepbx_config
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
voice:pbx:freepbx:freepbx_config [2014/02/28 09:46] gcooper |
voice:pbx:freepbx:freepbx_config [2021/12/03 11:15] (current) gcooper |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== FreePBX Configuration ====== | ====== FreePBX Configuration ====== | ||
| + | |||
| + | https:// | ||
| FIXME Incomplete | FIXME Incomplete | ||
| Line 211: | Line 213: | ||
| ==== Vitelity ==== | ==== Vitelity ==== | ||
| - | :!: Add separate inbound and outbound | + | :!: Add separate inbound and outbound |
| === Inbound === | === Inbound === | ||
| + | |||
| + | https:// | ||
| == General Settings == | == General Settings == | ||
| - | Trunk Name: vitel-inbound | + | |Trunk Name |'' |
| - | Outbound Caller ID: Your Name < | + | |Outbound Caller ID |'' |
| == Outgoing Settings == | == Outgoing Settings == | ||
| - | Trunk Name: vitel-inbound | + | |Trunk Name |'' |
| == Peer Details == | == Peer Details == | ||
| Line 244: | Line 248: | ||
| === Outbound === | === Outbound === | ||
| + | |||
| + | https:// | ||
| == General Settings == | == General Settings == | ||
| - | Trunk Name: vitel-outbound | + | |Trunk Name |'' |
| - | Outbound Caller ID: Your Name < | + | |Outbound Caller ID |'' |
| - | Maximum Channels: Set to the number of simultaneous calls you expect on a regular basis. | + | |Maximum Channels |
| == Dialed Number Manipulation Rules == | == Dialed Number Manipulation Rules == | ||
| Line 266: | Line 272: | ||
| == Outgoing Settings == | == Outgoing Settings == | ||
| - | Trunk Name: vitel-outbound | + | |Trunk Name |'' |
| Peer Details: | Peer Details: | ||
| Line 286: | Line 292: | ||
| :!: If your PBX will use IP Routing (recommended by Vitelity), do not enter a registration string. | :!: If your PBX will use IP Routing (recommended by Vitelity), do not enter a registration string. | ||
| - | :!: If your PBX is behind a dynamic IP address (which changes occasionally), | + | :!: If your PBX is behind a dynamic IP address (which changes occasionally), |
| Registration String: | Registration String: | ||
| Line 298: | Line 304: | ||
| ==== Inbound ==== | ==== Inbound ==== | ||
| - | Description: Default | + | |Description |
| - | + | |DID Number | |
| - | DID Number: The called number; usually your account number | + | |Set Destination |
| - | + | ||
| - | Set Destination: Usually an extension, ring group or IVR | + | |
| ==== Outbound ==== | ==== Outbound ==== | ||
| - | Route Name: Default | + | |Route Name |
| - | Emergency: Enabled if this route is used to call 911 | + | |Emergency |
| === Dial Patterns === | === Dial Patterns === | ||
| - | * International | + | * '' |
| - | * Long distance | + | * '' |
| - | * Long distance (no 1) | + | * '' |
| - | * Local | + | * '' |
| - | * Emergency (only if e911 service is on this trunk) | + | * '' |
| < | < | ||
| Line 325: | Line 329: | ||
| </ | </ | ||
| - | Pick a trunk or two. | + | === Trunk Sequence for Matched Routes === |
| - | **Inbound Routes** | + | Pick a trunk or two (vitel-outbound). |
| - | Route Name: Default | ||
| - | Set Destination: | ||
voice/pbx/freepbx/freepbx_config.1393605967.txt.gz · Last modified: 2014/02/28 09:46 by gcooper
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
