User Tools
voice:pbx:freepbx:freepbx_config
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
voice:pbx:freepbx:freepbx_config [2014/02/28 09:28] gcooper |
voice:pbx:freepbx:freepbx_config [2021/12/03 11:15] (current) gcooper |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== FreePBX Configuration ====== | ====== FreePBX Configuration ====== | ||
| + | |||
| + | https:// | ||
| FIXME Incomplete | FIXME Incomplete | ||
| Line 211: | Line 213: | ||
| ==== Vitelity ==== | ==== Vitelity ==== | ||
| - | :!: Add separate inbound and outbound | + | :!: Add separate inbound and outbound |
| === Inbound === | === Inbound === | ||
| + | |||
| + | https:// | ||
| == General Settings == | == General Settings == | ||
| - | Trunk Name: vitel-inbound | + | |Trunk Name |'' |
| - | Outbound Caller ID: Your Name < | + | |Outbound Caller ID |'' |
| == Outgoing Settings == | == Outgoing Settings == | ||
| - | Trunk Name: vitel-inbound | + | |Trunk Name |'' |
| == Peer Details == | == Peer Details == | ||
| Line 244: | Line 248: | ||
| === Outbound === | === Outbound === | ||
| + | |||
| + | https:// | ||
| == General Settings == | == General Settings == | ||
| - | Trunk Name: vitel-outbound | + | |Trunk Name |'' |
| - | Outbound Caller ID: Your Name < | + | |Outbound Caller ID |'' |
| - | Maximum Channels: Set to the number of simultaneous calls you expect on a regular basis. | + | |Maximum Channels |
| == Dialed Number Manipulation Rules == | == Dialed Number Manipulation Rules == | ||
| Line 266: | Line 272: | ||
| == Outgoing Settings == | == Outgoing Settings == | ||
| - | Trunk Name: vitel-outbound | + | |Trunk Name |'' |
| Peer Details: | Peer Details: | ||
| Line 286: | Line 292: | ||
| :!: If your PBX will use IP Routing (recommended by Vitelity), do not enter a registration string. | :!: If your PBX will use IP Routing (recommended by Vitelity), do not enter a registration string. | ||
| - | :!: If your PBX is behind a dynamic IP address (which changes occasionally), | + | :!: If your PBX is behind a dynamic IP address (which changes occasionally), |
| Registration String: | Registration String: | ||
| Line 294: | Line 300: | ||
| </ | </ | ||
| - | ==== Routes ==== | + | ===== Routes |
| - | === Inbound === | + | ==== Inbound |
| - | === Outbound === | + | |Description |
| + | |DID Number | ||
| + | |Set Destination |Usually an extension, ring group or IVR | | ||
| - | Route Name: Default | + | ==== Outbound ==== |
| - | Emergency: enabled | + | |
| - | Dial Patterns: | + | |
| - | 011. | + | |Route Name |'' |
| - | 1NXXNXXXXXX | + | |Emergency |
| - | NXXNXXXXXX | + | |
| - | NXXXXXX | + | === Dial Patterns === |
| + | |||
| + | * '' | ||
| + | * '' | ||
| + | * '' | ||
| + | * '' | ||
| + | * '' | ||
| + | |||
| + | < | ||
| + | + |011. | ||
| + | | ||
| + | | ||
| + | | ||
| + | + |911 | ||
| + | </ | ||
| - | Pick a trunk or two. | + | === Trunk Sequence for Matched Routes === |
| - | **Inbound Routes** | + | Pick a trunk or two (vitel-outbound). |
| - | Route Name: Default | ||
| - | Set Destination: | ||
voice/pbx/freepbx/freepbx_config.1393604908.txt.gz · Last modified: 2014/02/28 09:28 by gcooper
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
