Differences

This shows you the differences between two versions of the page.

--- voice:grandstream_paging [2021/10/28 15:49]
gcooper
+++ voice:grandstream_paging [2021/10/28 16:10] (current)
gcooper
@@ Line 30: / Line 30: @@
 <note>The Cisco/Linksys SPA-3102 is a multi-function ATA with one FXS and one FXO port (LINE).  We can use the FXO port to drive a separate paging amplifier.</note>
+<note important>Reset the SPA to factory using an analog phone.  Dial ''****'' to access in the IVR menu, then dial 73738# and lastly press 1 to confirm the reset.</note>
   - **Configure the Viking PA-2A** as above
@@ Line 42: / Line 44: @@
     - **Voice -> Info** (tab)
       - Note the **Line Voltage** (24V?)
-    - **PSTN Line** (tab)
+    - **Voice -> PSTN Line** (tab)
-      - Configure the Line-in-Use Voltage on the PSTN Line tab as the same voltage
+      - Configure the **Line-in-Use Voltage** the same voltage as previously noted
-      - Configure the Proxy and Registration
+      - Configure the **Proxy and Registration** settings
+        - **Proxy** -> PBX IP address
+        - **Register** -> no
+        - **Make Call Without Reg** -> yes
+        - **Ans Call Without Reg** -> yes
 {{ :voice:spa-3102_paging_settings.png?direct&750 |Proxy and Registration Settings for Paging}}
+{{ :voice:freepbx_paging_trunk_1.png?direct&750 |Create a Paging Trunk}}
+FIXME
 ===== Grandstream UCM610X PBX =====

Virtual Architects Support Wiki