Differences

This shows you the differences between two versions of the page.

--- voice:grandstream_paging [2021/10/28 15:08]
gcooper
+++ voice:grandstream_paging [2021/10/28 16:10] (current)
gcooper
@@ Line 31: / Line 31: @@
 <note>The Cisco/Linksys SPA-3102 is a multi-function ATA with one FXS and one FXO port (LINE).  We can use the FXO port to drive a separate paging amplifier.</note>
-  - Configure the Viking PA-2A as above
+<note important>Reset the SPA to factory using an analog phone.  Dial ''****'' to access in the IVR menu, then dial 73738# and lastly press 1 to confirm the reset.</note>
-  - Connect the FXO port to screw terminals 5 & 6 on the SPA-3102
-  - Connect the speaker horn to screw terminals 9 & 10 on the SPA-3102
+  - **Configure the Viking PA-2A** as above
-  -
+    - Connect the **FXO port** to screw terminals 5 & 6 on the SPA-3102
+    - Connect the **speaker** horn to screw terminals 9 & 10 on the SPA-3102
+  - **Configure the Linksys SPA-3102**
+    - Connect the SPA-3102 **WAN port to the same network as your PBX**
+    - Connect your **PC to the LAN port**
+    - http://192.168.0.1/admin/advanced
+    - **Router -> WAN Setup** (tab)
+      - Configure a **static IP address for the WAN port** (or a DHCP reservation)
+    - **Voice -> Info** (tab)
+      - Note the **Line Voltage** (24V?)
+    - **Voice -> PSTN Line** (tab)
+      - Configure the **Line-in-Use Voltage** the same voltage as previously noted
+      - Configure the **Proxy and Registration** settings
+        - **Proxy** -> PBX IP address
+        - **Register** -> no
+        - **Make Call Without Reg** -> yes
+        - **Ans Call Without Reg** -> yes
+{{ :voice:spa-3102_paging_settings.png?direct&750 |Proxy and Registration Settings for Paging}}
+{{ :voice:freepbx_paging_trunk_1.png?direct&750 |Create a Paging Trunk}}
+FIXME
 ===== Grandstream UCM610X PBX =====

Virtual Architects Support Wiki

User Tools

Site Tools

Differences

Page Tools