Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » voice » ata » spa3102
Trace: • backup_grooming
voice:ata:spa3102

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
voice:ata:spa3102 [2021/10/27 12:09]
gcooper 		voice:ata:spa3102 [2021/10/27 12:15] (current)
gcooper
Line 37: Line 37:
 http://wiki.freepbx.org/display/FOP/Using+an+SPA3102+FXO+Port+to+connect+with+Valcom+Paging+units http://wiki.freepbx.org/display/FOP/Using+an+SPA3102+FXO+Port+to+connect+with+Valcom+Paging+units
  
-Three steps in this process:+==== Overview ====
  
   - Configure a SIP Trunk and Outbound Route in FreePBX   - Configure a SIP Trunk and Outbound Route in FreePBX
Line 43: Line 43:
   - Determine "Line-In-Use Voltage" of the FXO port and adjust it to match   - Determine "Line-In-Use Voltage" of the FXO port and adjust it to match
     - Otherwise inbound calls in will result in a busy signal (SIP response 503 "Service Unavailable")     - Otherwise inbound calls in will result in a busy signal (SIP response 503 "Service Unavailable")
 +
 +
  
 ===== Enable the Web Interface on WAN ===== ===== Enable the Web Interface on WAN =====
voice/ata/spa3102.1635358173.txt.gz · Last modified: 2021/10/27 12:09 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki