Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » virtualization » xenserver » xenserver_networking
Trace:
virtualization:xenserver:xenserver_networking

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
virtualization:xenserver:xenserver_networking [2017/02/26 10:01]
gcooper 		virtualization:xenserver:xenserver_networking [2019/10/30 12:19] (current)
gcooper
Line 84: Line 84:
  
 If you are not using XenCenter for NIC bonding, the quickest way to create pool-wide NIC bonds is to create the bond on the master, and then restart the other pool members. Alternatively, you can use the service xapi restart command. This causes the bond and VLAN settings on the master to be inherited by each host. The management interface of each host must, however, be manually reconfigured. If you are not using XenCenter for NIC bonding, the quickest way to create pool-wide NIC bonds is to create the bond on the master, and then restart the other pool members. Alternatively, you can use the service xapi restart command. This causes the bond and VLAN settings on the master to be inherited by each host. The management interface of each host must, however, be manually reconfigured.
 +
 +==== XenCenter ====
 +
 +**Select Host -> NICs (tab) -> Create Bond**
 +
 +==== CLI ====
  
 <file> <file>
virtualization/xenserver/xenserver_networking.1488128465.txt.gz · Last modified: 2017/02/26 10:01 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki