User Tools
quick_guide:ras_audio
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
quick_guide:ras_audio [2017/12/29 11:57] gcooper created |
quick_guide:ras_audio [2017/12/29 12:00] (current) gcooper |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== No Audio ===== | ===== No Audio ===== | ||
| - | - Check that the volume setting of the speakers | + | - **Check that the volume setting of the speakers** |
| - built-in monitor speakers | - built-in monitor speakers | ||
| - | - set both monitors' | + | - **set both monitors' |
| - this is harder than it sounds because monitors are all different | - this is harder than it sounds because monitors are all different | ||
| - you can skip step 1 and move on to steps 2, then 3, only returning to step 1 if unsuccessful | - you can skip step 1 and move on to steps 2, then 3, only returning to step 1 if unsuccessful | ||
| - | - Check the volume setting of your workstation | + | - **Check the volume setting of your workstation** |
| - | - not the remote session | + | - not the remote session with blue bar at top |
| - | - set it to 100% | + | |
| - | - Finally, check the volume setting in your remote session | + | - **Finally, check the volume setting in your remote session** |
| - blue bar is at the top | - blue bar is at the top | ||
| - QM Desktop remote session | - QM Desktop remote session | ||
| - | - set volume to 100% | + | |
| - | - adjust to your desired volume here after it makes sound | + | - adjust to your desired volume here **after it makes sound** |
| - | + | ||
| - | Skip a step = fail! | + | |
| ===== Low Audio Volume ===== | ===== Low Audio Volume ===== | ||
quick_guide/ras_audio.1514573861.txt.gz · Last modified: 2017/12/29 11:57 by gcooper
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
