Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » networking » wireless » unifi
Trace: • mikrotik_nat
networking:wireless:unifi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
networking:wireless:unifi [2024/08/16 10:41]
gcooper 		networking:wireless:unifi [2024/08/19 11:17] (current)
gcooper
Line 31: Line 31:
 <note tip>Consider using a Docker-based configuration.</note> <note tip>Consider using a Docker-based configuration.</note>
  
-====== Server Prep ======+===== Server =====
  
 [[internet:mail:zimbra:zimbra_ose#server_preparation|Server Prep]]   [[internet:mail:zimbra:zimbra_ose#server_preparation|Server Prep]]  
  
-===== Controller Installation =====+==== Unifi Installation ====
  
 :!: Unifi Controller seems to be easy to install, run and update under **Docker**.  See below. :!: Unifi Controller seems to be easy to install, run and update under **Docker**.  See below.
Line 82: Line 82:
 </file> </file>
  
-==== Management ====+===== Management =====
  
-=== Browser ===+==== Browser ====
  
 https://ip.of.controller:8443 https://ip.of.controller:8443
Line 91: Line 91:
 ^Default Password |''123456''   | ^Default Password |''123456''   |
  
-=== SSH ===+==== SSH ====
  
 ^Default Username |''ubnt''     | ^Default Username |''ubnt''     |
Line 107: Line 107:
   * ''Country''   * ''Country''
   * ''Time Zone''   * ''Time Zone''
-  * ''Device Authentication'' 
  
 **Select the site -> Settings -> Wireless Networks** **Select the site -> Settings -> Wireless Networks**
Line 142: Line 141:
 Simple guest access uses single DHCP server and restricts access to Internet only. Simple guest access uses single DHCP server and restricts access to Internet only.
  
-<note tip>These steps are no longer correct for Controller V8. Guest networks are now created by selecting ''Manual'' configuration and enabling ''Hotstop Portal''.  You configure the user experience by managing the Hotspot Portal.</note>+<note tip>These steps are no longer correct for Controller V8. Guest networks are now created by selecting ''Manual'' configuration and enabling ''Hotspot Portal''.  You configure the user experience by managing the Hotspot Portal.</note>
  
   * To **restrict bandwidth of guests**, create a "Guests" User Group   * To **restrict bandwidth of guests**, create a "Guests" User Group
Line 179: Line 178:
 ==== L3 Adoption ==== ==== L3 Adoption ====
  
-http://www.youtube.com/watch?v=y5tkToD_nds+**Docs**: https://help.ui.com/hc/en-us/articles/204909754-Remote-Adoption-Layer-3 
 + 
 +**HowTo**: http://www.youtube.com/watch?v=y5tkToD_nds
  
   - Install AP   - Install AP
networking/wireless/unifi.1723826504.txt.gz · Last modified: 2024/08/16 10:41 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki