This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
networking:switch:cisco_4948 [2017/08/08 13:53] gcooper |
networking:switch:cisco_4948 [2022/08/11 10:07] (current) gcooper |
||
---|---|---|---|
Line 35: | Line 35: | ||
ip vrf mgmtVrf | ip vrf mgmtVrf | ||
ip vrf forwarding mgmtVrf | ip vrf forwarding mgmtVrf | ||
- | ip address 10.10.4.11 255.255.255.0 | + | ip address 10.0.4.11 255.255.255.0 |
speed auto | speed auto | ||
duplex auto | duplex auto | ||
Line 41: | Line 41: | ||
no shutdown | no shutdown | ||
- | ip route vrf mgmtVrf 0.0.0.0 0.0.0.0 10.10.4.1 | + | ip route vrf mgmtVrf 0.0.0.0 0.0.0.0 10.0.4.1 |
- | ip default-gateway 10.10.4.1 | + | ip default-gateway 10.0.4.1 |
ip http server | ip http server | ||
ip ftp source-interface fa1 | ip ftp source-interface fa1 | ||
Line 71: | Line 71: | ||
Example MGMT addresses: | Example MGMT addresses: | ||
- | VLAN 10 - network 10.10.10.0/24 | + | VLAN 10 - network 10.0.10.0/24 |
- | Switch 1: IP 10.10.10.2/24 | + | Switch 1: IP 10.0.10.2/24 |
- | Switch 2: IP 10.10.10.3/24 | + | Switch 2: IP 10.0.10.3/24 |
- | Switch 3: IP 10.10.10.4/24 | + | Switch 3: IP 10.0.10.4/24 |
... | ... | ||
Line 299: | Line 299: | ||
show interfaces | include output err | show interfaces | include output err | ||
show interfaces status | include connected | show interfaces status | include connected | ||
+ | show run | b username | ||
show standby brief | show standby brief | ||
show etherchannel summary | show etherchannel summary | ||
Line 328: | Line 328: | ||
exit | exit | ||
exit | exit | ||
+ | </ | ||
+ | |||
+ | ===== LACP Port Bonding ===== | ||
+ | |||
+ | Configure the channel group (channel group 1 example shown here): | ||
+ | |||
+ | < | ||
+ | Router> enable | ||
+ | Router# configure terminal | ||
+ | Router(config)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | </ | ||
+ | |||
+ | Configure the ports (gigabit ports 33 and 34 in this example): | ||
+ | |||
+ | < | ||
+ | Router(config)# | ||
+ | Router(config-if-range)# | ||
+ | Router(config-if-range)# | ||
+ | Router(config-if-range)# | ||
+ | Router(config-if)# | ||
+ | Router# show lacp internal | ||
</ | </ | ||
Line 414: | Line 439: | ||
</ | </ | ||
+ | ===== Backup and Restore ===== | ||
+ | https:// |