Differences

This shows you the differences between two versions of the page.

--- networking:router:mikrotik_bridge [2015/10/16 12:31]
gcooper
+++ networking:router:mikrotik_bridge [2015/10/16 13:08] (current)
gcooper
@@ Line 17: / Line 17: @@
   * Use Winbox for layer 2 configuration
     * not default IP address
+  * Upgrade the RouterOS on all devices first
+  * Delay mounting until all is tested
+  * You should be able to use DHCP on your workstation after establishing the bridge connection
 ===== Configuration of Bridge Mode Device =====
   - Bridge the Ethernet and the wireless interfaces together
-  - Assign a management IP address to the bridge
+    - ''Bridge''
-    * or use DHCP reservation
+  - Assign a management IP address to the bridge or use DHCP reservation
+    - ''IP'' -> ''Addresses''
   - Remove the default IP address from ''ether1''
+  - Assign an appropriate identity to each device
+    - ''System'' -> ''Identity''
   - Configure the wireless interface
     - ''Wireless'' tab -> ''Advanced Mode''
@@ Line 37: / Line 43: @@
     - Click ''Apply''
+===== Configuration of Station Bridge Device(s) =====
+:!: **Most settings are the same as the Bridge Mode Device.**
+  - Use a different management IP address
+  - Set a different identity
+  - Set the ''Mode'' -> ''station bridge''
+  - Select ''Apply''

Virtual Architects Support Wiki