Differences

This shows you the differences between two versions of the page.

--- networking:router:mikrotik_bridge [2015/10/16 11:21]
gcooper created
+++ networking:router:mikrotik_bridge [2015/10/16 13:08] (current)
gcooper
@@ Line 12: / Line 12: @@
     * **192.168.88.1**
     * on **ether1**
+  * The default credentials
+    * **admin**
+    * with no password
+  * Use Winbox for layer 2 configuration
+    * not default IP address
+  * Upgrade the RouterOS on all devices first
+  * Delay mounting until all is tested
+  * You should be able to use DHCP on your workstation after establishing the bridge connection
+===== Configuration of Bridge Mode Device =====
+  - Bridge the Ethernet and the wireless interfaces together
+    - ''Bridge''
+  - Assign a management IP address to the bridge or use DHCP reservation
+    - ''IP'' -> ''Addresses''
+  - Remove the default IP address from ''ether1''
+  - Assign an appropriate identity to each device
+    - ''System'' -> ''Identity''
+  - Configure the wireless interface
+    - ''Wireless'' tab -> ''Advanced Mode''
+      - ''Frequency Mode'' -> ''regulatory-domain''
+      - ''Country'' -> ''united states''
+      - ''Mode'' -> ''ap-bridge'' or just ''bridge''
+        * Multi-point systems need Level 4 license for ''ap-bridge''
+      - ''SSID'' -> your bridge SSID
+      - ''Wireless Protocol'' -> ''nv2''
+    - ''NV2'' tab
+      - Select the ''Security'' box
+      - Enter a ''Preshared Key''
+    - Click ''Apply''
+===== Configuration of Station Bridge Device(s) =====
+:!: **Most settings are the same as the Bridge Mode Device.**
+  - Use a different management IP address
+  - Set a different identity
+  - Set the ''Mode'' -> ''station bridge''
+  - Select ''Apply''

Virtual Architects Support Wiki

User Tools

Site Tools

Differences

Page Tools