Differences

This shows you the differences between two versions of the page.

--- networking:monitoring:wattbox [2015/08/28 15:25]
jcooper
+++ networking:monitoring:wattbox [2015/08/29 17:11] (current)
jcooper
@@ Line 5: / Line 5: @@
 **Documentation**: http://www.av-iq.com/avcat/images/documents/dataSheet/2312.pdf
-Evaluating the WattBox WB-200-IPCE-3 I found it to be a capable remote controlled surge suppressor.
+Evaluating the WattBox WB-200-IPCE-3 I found it to be a capable remote controlled per port surge suppressor.
-It has the ability to use ICMP to determine if a device/Internet is accessible and do an auto power off/on of a port.  I.E. reboot Cable Modem/DSL to attempt reconnect of Internet.
+  * It has the ability to use ICMP to determine if a device/Internet is accessible and do an auto power off/on of a port.  I.E. reboot Cable Modem/DSL to attempt reconnect of Internet.
-You can also schedule unattended power cycle of the ports.
+  * You can schedule unattended power cycle of the ports.
-It also can send email alerts on conditions.
+  * It also can send email alerts on conditions.
+:!: I was not able to make the email option work on Zimbra or Gmail accounts.  Does not appear to support encryption.  It did work with mail.sonoracomm.com.
 ===== Setup =====
@@ Line 17: / Line 19: @@
 http://www.dailymotion.com/video/x16znav_wattbox-wb-200-ipce-3-tutorial_tech
-  * The "Power on Delay" settings are connected to the auto power cycle determined by the result of the ICMP availability of a host.  The delay is the amount of time the port will be without power.  Handy for devices that need to be in a certain condition (booted up) before another device comes on.
+:!: Default credentials User:admin Password: <none, leave "Password" field blank>
+  * The "Power on Delay" settings are connected to the auto power cycle function triggered by the result of the ICMP availability of a host.  The delay is the amount of time the port will be without power.  Handy for devices that need to be in a certain condition (booted up) before another device comes on.
+  * Auto Reboot must be enabled on the WattBox, disabled by default.
 https://www.youtube.com/watch?v=HDx6FiR_La4
 :!: The videos and documentation will tell you to install the configuration software. This is to find the device on your network. Determine the devices IP address via DHCP log etc. and use your browser making the install unnecessary.
   * WattBox has their own DynDNS system so you can remotely access the device via HTTP (port configurable) if you forward the port to your WattBox.
+===== Firmware Updates =====
+:!: Firmware updates can only be done with the configuration software.
+https://www.onaisle8.com/wcsstore/ExtendedSitesCatalogAssetStore/attachments/documents/PowerManagement/SoftwareAndFirmware/WB-IP_FirmwareUpdateInstructions.pdf
 ===== OVRC =====

Virtual Architects Support Wiki

User Tools

Site Tools

Differences

Page Tools