Differences

This shows you the differences between two versions of the page.

--- networking:linux:qlproxy [2011/12/24 15:27]
gcooper
+++ networking:linux:qlproxy [2011/12/24 15:38] (current)
gcooper
@@ Line 14: / Line 14: @@
 http://issues.quintolabs.com/trac/quintolabs_qlicap/wiki/QlicapDocsInstall
+==== Install System ====
+[[computing:linux:minimal_centos_install|Minimal CentOS Install]]
+This may work on either 32-bit or 64-bit systems.
 ==== Install Requirements ====
@@ Line 21: / Line 27: @@
 chkconfig squid on
-service squid start
 chkconfig httpd on
-service httpd start
 </file>
@@ Line 43: / Line 47: @@
 ==== Selinux ====
+Set to permissive for now:
+<file>
+vi /etc/selinux/config
+</file>
 ==== Configure Squid ====
@@ Line 64: / Line 74: @@
 adaptation_access qlproxy1 allow all
 adaptation_access qlproxy2 allow all
-</file>
-Restart Squid proxy:
-<file>
-service squid restart
 </file>
@@ Line 89: / Line 93: @@
 EOF
 </file>
+**Now reboot!**

Virtual Architects Support Wiki