Differences

This shows you the differences between two versions of the page.

--- networking:linux:ftp_server [2016/10/18 12:00]
gcooper
+++ networking:linux:ftp_server [2016/11/01 08:58] (current)
gcooper
@@ Line 4: / Line 4: @@
 https://ftptest.net/Help
+http://doxfer.webmin.com/Webmin/ProFTPD_Server
+{{ :networking:linux:ftp_nat_diagram.png?750 |FTP Behind NAT Diagram}}
 In **passive mode**, the router and firewall on the **server side** need to be configured to accept and forward incoming connections. On the client side however, only outgoing connections have to be allowed, which will already be the case most of the time.
@@ Line 11: / Line 15: @@
 Since usually one server provides a service for many users, it is **far easier to just configure the router and firewall on the server side once for passive mode**, than to configure the client's router/firewall for each individual client in active mode. That is why passive mode is recommended.
-{{ :networking:linux:ftp_nat_diagram.png?750 |FTP Behind NAT Diagram}}
+{{ :networking:linux:mikrotik_nat_ftp.png?750 |Mikrotik Port Forwarding}}
 ===== Troubleshooting =====
@@ Line 20: / Line 24: @@
   * Try configuring your client for **SFTP Mode**
   * Try configuring your client for **Active Mode**
-  * Try disabling the Windows Firewall on your client PC
+  * Try **disabling the Windows Firewall** on your client PC
 </note>

Virtual Architects Support Wiki