Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » internet » mail » exchange » exchange_local_relay
Trace:
internet:mail:exchange:exchange_local_relay

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
internet:mail:exchange:exchange_local_relay [2019/05/28 09:21]
gcooper 		internet:mail:exchange:exchange_local_relay [2019/05/28 09:26] (current)
gcooper
Line 5: Line 5:
 Be default, Exchange will not relay mail for anonymous users.  **This complicates sending mail from local appliances such as a PBX or copier.** Be default, Exchange will not relay mail for anonymous users.  **This complicates sending mail from local appliances such as a PBX or copier.**
  
-==== Add a Receive Connector ====+==== Add a Local Relay Receive Connector ====
  
 Here we add a new Receive Connector "Local Relay" that permits a short list of devices (IP addresses) permitted to relay mail without authentication.  If you add a new appliance that needs to send mail, do not configure SMTP Authentication.  Add its IP address to the list of permitted devices instead. Here we add a new Receive Connector "Local Relay" that permits a short list of devices (IP addresses) permitted to relay mail without authentication.  If you add a new appliance that needs to send mail, do not configure SMTP Authentication.  Add its IP address to the list of permitted devices instead.
internet/mail/exchange/exchange_local_relay.1559056915.txt.gz · Last modified: 2019/05/28 09:21 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki