Differences

This shows you the differences between two versions of the page.

--- internet:mail:exchange:exchange_local_relay [2019/05/28 09:12]
gcooper
+++ internet:mail:exchange:exchange_local_relay [2019/05/28 09:26] (current)
gcooper
@@ Line 5: / Line 5: @@
 Be default, Exchange will not relay mail for anonymous users.  **This complicates sending mail from local appliances such as a PBX or copier.**
-==== Add a Receive Connector ====
+==== Add a Local Relay Receive Connector ====
-{{ :internet:mail:exchange:exchange_local_relay_connector_1.png?600 |}}
+Here we add a new Receive Connector "Local Relay" that permits a short list of devices (IP addresses) permitted to relay mail without authentication.  If you add a new appliance that needs to send mail, do not configure SMTP Authentication.  Add its IP address to the list of permitted devices instead.
-{{ :internet:mail:exchange:exchange_local_relay_connector_2.png?600 |}}
+**Exchange Admin Center -> Mail Flow -> Receive Connectors**
-{{ :internet:mail:exchange:exchange_local_relay_connector_3.png?600 |}}
+{{ :internet:mail:exchange:exchange_local_relay_connector_1.png?600 |Add a new Receive Connector}}
-{{ :internet:mail:exchange:exchange_local_relay_connector_4.png?600 |}}
+{{ :internet:mail:exchange:exchange_local_relay_connector_2.png?600 |Bind it to port 25}}
-{{ :internet:mail:exchange:exchange_local_relay_connector_5.png?600 |}}
+{{ :internet:mail:exchange:exchange_local_relay_connector_3.png?600 |Delete the default range of permitted IPs}}
+{{ :internet:mail:exchange:exchange_local_relay_connector_4.png?600 |Add the IP addresses of permitted devices}}
+{{ :internet:mail:exchange:exchange_local_relay_connector_5.png?750 |New Local Relay Receive Connector}}
 ===== Exchange 2007 =====

Virtual Architects Support Wiki

User Tools

Site Tools

Differences

Page Tools