Differences

This shows you the differences between two versions of the page.

--- computing:storage:napp-it [2021/05/10 13:58]
gcooper
+++ computing:storage:napp-it [2025/01/28 08:47] (current)
gcooper
@@ Line 8: / Line 8: @@
 See also **[[https://www.napp-it.org/doc/downloads/flash_lsi_sas.pdf|Flash LSI IR to IT Mode]]**
+**License Swap**: http://napp-it.org/extensions/swap_en.html
 **Official Handbook**: http://www.napp-it.org/doc/downloads/napp-it.pdf
@@ Line 123: / Line 125: @@
 :!: Napp-IT should only be used on secure networks.  SSL is not available by default on the web interface.
-:!: Delete ''napp-it.cfg'' to reset to defaults.
+:!: Delete '' /var/web-gui/_log/napp-it.cfg'' to reset to defaults.
 Using a web browser:
@@ Line 421: / Line 423: @@
 {{ :computing:storage:napp-it_zfs_diskinfos.png?750 |ZFS Disk Errors}}
-===== Replace a Failed Disk =====
+==== Replace a Failed Disk ====
 In the web GUI:
@@ Line 430: / Line 432: @@
   * Select the new drive you already installed
   * Click 'Replace'
+If you simply replace a failed boot drive with another drive (system off), you can then:
+<file>
+zpool status rpool
+zpool replace rpool device
+</file>
+==== rpool ====
+https://omnios.org/info/migrate_rpool
+Install the boot block and boot loader of mirrored boot drives:
+<file>
+bootadm install-bootloader -P rpool
+</file>
+:!: Test or switch boot drives in the system BIOS.
 ===== File Manager =====

Virtual Architects Support Wiki