Differences

This shows you the differences between two versions of the page.

--- computing:storage:lsi:megaraid [2020/10/12 14:18]
gcooper
+++ computing:storage:lsi:megaraid [2020/10/12 14:27] (current)
gcooper
@@ Line 209: / Line 209: @@
 :!: This tool works on HBAs.
+**Manual**: https://docs.broadcom.com/doc/12355769
+  * ''-o'' enable advanced commands
+  * ''-c'' controller
   * ''-f'' firmware
   * ''-b'' BIOS
@@ Line 266: / Line 270: @@
 There is no need to load the ''mptsas2.rom'' unless you want to boot from a disk connected to the HBA cards (just use the SATA ports for boot, or USB).
-The above is all true too if you use the UEFI installer which is recommended.  The command is sas2flash.efi instead.  The command map lists all drives in the EFI shell.  Change drives in UEFI like dos ''DriveName:'' to change dir.
+The above is also true if you use the UEFI installer which is recommended.  The command is sas2flash.efi instead.  The command map lists all drives in the EFI shell.  Change drives in UEFI like DOS ''DriveName:'' to change dir.
 ===== CacheCade 2.0 SSD Caching =====

Virtual Architects Support Wiki