Virtual Architects Support Wiki

User Tools

Site Tools

You are here: start » computing » storage » lsi » megaraid
Trace:
computing:storage:lsi:megaraid

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
computing:storage:lsi:megaraid [2020/05/21 13:24]
gcooper 		computing:storage:lsi:megaraid [2020/10/12 14:27] (current)
gcooper
Line 208: Line 208:
  
 :!: This tool works on HBAs. :!: This tool works on HBAs.
 +
 +**Manual**: https://docs.broadcom.com/doc/12355769
 +
 +  * ''-o'' enable advanced commands
 +  * ''-c'' controller
 +  * ''-f'' firmware
 +  * ''-b'' BIOS
 +  * ''-u'' backup
 +  * ''-l'' log
  
 Example to boot from USB DOS drive, backup and update 9207-8i HBA firmware and BIOS: Example to boot from USB DOS drive, backup and update 9207-8i HBA firmware and BIOS:
Line 224: Line 233:
 ==== Other People's Notes ==== ==== Other People's Notes ====
  
-Use Rufus to make a FreeDOS USB boot volume+:!: Use Rufus to make a FreeDOS USB boot volume.
  
 Copy: Copy:
Line 233: Line 242:
 </file> </file>
  
-to the root of the USB+to the root of the USB flash drive.
  
-Boot from USB+Boot from the USB flash drive.
  
 execute: execute:
Line 243: Line 252:
 </file> </file>
  
-note the numbers of the 2 cards (should be 0 and 1)+:!: Note the numbers of the 2 cards (should be 0 and 1).
  
-execute:+Execute:
  
 <file> <file>
Line 261: Line 270:
 There is no need to load the ''mptsas2.rom'' unless you want to boot from a disk connected to the HBA cards (just use the SATA ports for boot, or USB). There is no need to load the ''mptsas2.rom'' unless you want to boot from a disk connected to the HBA cards (just use the SATA ports for boot, or USB).
  
-The above is all true too if you use the UEFI installer which is recommended.  The command is sas2flash.efi instead.  The command map lists all drives in the EFI shell.  Change drives in UEFI like dos ''DriveName:'' to change dir.+The above is also true if you use the UEFI installer which is recommended.  The command is sas2flash.efi instead.  The command map lists all drives in the EFI shell.  Change drives in UEFI like DOS ''DriveName:'' to change dir.
  
 ===== CacheCade 2.0 SSD Caching ===== ===== CacheCade 2.0 SSD Caching =====
computing/storage/lsi/megaraid.1590089041.txt.gz · Last modified: 2020/05/21 13:24 by gcooper

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki