User Tools
networking:linux:static_ip_addr
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
networking:linux:static_ip_addr [2021/08/20 09:58] gcooper |
networking:linux:static_ip_addr [2023/03/02 11:19] gcooper |
||
|---|---|---|---|
| Line 40: | Line 40: | ||
| * DHCP addresses | * DHCP addresses | ||
| - | ==== Ubuntu 20.04 (bonded) ==== | + | ==== Regenerate and Reapply After Editing ==== |
| + | |||
| + | < | ||
| + | sudo netplan --debug generate | ||
| + | sudo netplan --debug apply | ||
| + | </ | ||
| + | |||
| + | ==== Ubuntu | ||
| < | < | ||
| network: | network: | ||
| + | version: 2 | ||
| + | ethernets: | ||
| + | enp0s8: | ||
| + | dhcp4: no | ||
| + | enp0s9: | ||
| + | dhcp4: no | ||
| bonds: | bonds: | ||
| bond0: | bond0: | ||
| - | interfaces: | + | interfaces: |
| - | - enp0s8 | + | |
| - | - enp0s9 | + | |
| addresses: [10.1.1.19/ | addresses: [10.1.1.19/ | ||
| - | | + | |
| + | - to: default | ||
| + | via: 10.1.1.1 | ||
| nameservers: | nameservers: | ||
| - | | + | |
| - | addresses: [10.1.1.20, 10.1.1.21] | + | addresses: [10.1.1.20, 10.1.1.21] |
| parameters: | parameters: | ||
| - | mode: balance-rr | + | mode: 802.3ad |
| - | ethernets: | + | transmit-hash-policy: layer3+4 |
| - | | + | |
| - | enp0s9: {} | + | |
| - | version: 2 | + | |
| </ | </ | ||
| - | ==== Ubuntu 18.04 ==== | + | ==== Ubuntu 18/20/22 (Static) |
| < | < | ||
| Line 68: | Line 79: | ||
| </ | </ | ||
| - | <note tip>To suppress (or define) the default IPv6 '' | + | <note tip>To suppress (or define) the default IPv6 '' |
| '' | '' | ||
| Line 77: | Line 88: | ||
| < | < | ||
| network: | network: | ||
| - | | + | |
| - | eth0: | + | eth0: |
| - | addresses: [10.1.1.17/ | + | addresses: [10.1.1.17/ |
| - | | + | |
| - | nameservers: | + | - to: 0.0.0.0/0 |
| - | addresses: [10.1.1.20, | + | via: 10.0.0.1 |
| - | eth1: | + | nameservers: |
| - | addresses: [10.1.9.17/ | + | addresses: [10.1.1.20, |
| - | mtu: 9000 | + | eth1: |
| - | version: 2 | + | addresses: [10.1.9.17/ |
| + | mtu: 9000 | ||
| + | version: 2 | ||
| </ | </ | ||
| - | < | + | ==== Troubleshooting ==== |
| - | sudo netplan --debug generate | + | |
| - | sudo netplan --debug apply | + | |
| - | </ | + | |
| - | If you have trouble, try removing these files, then regenerate and reapply: | + | If you have trouble |
| * Extra addresses | * Extra addresses | ||
| Line 129: | Line 139: | ||
| ===== Hostname ===== | ===== Hostname ===== | ||
| + | |||
| + | < | ||
| + | hostname short-hostname | ||
| + | hostnamectl set-hostname fqdn-host-name | ||
| + | </ | ||
| < | < | ||
| Line 134: | Line 149: | ||
| 192.168.1.30 | 192.168.1.30 | ||
| + | </ | ||
| - | sudo sh -c "echo new-hostname > / | + | < |
| - | + | echo new-hostname > / | |
| - | sudo hostnamectl set-hostname new-hostname | + | </ |
| + | < | ||
| hostname | hostname | ||
| hostname -f | hostname -f | ||
| Line 297: | Line 314: | ||
| reboot | reboot | ||
| </ | </ | ||
| + | |||
| + | ===== Grub Boot Delay ===== | ||
| + | |||
| + | < | ||
| + | sed -i -e ' | ||
| + | </ | ||
| + | |||
networking/linux/static_ip_addr.txt · Last modified: 2023/05/02 14:34 by gcooper
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
